The Following Works Were Used to Write this Piece on Grounding and Shielding
Dec 11, 2001 12:00 PM,
Philip Giddings
C. Atkinson and P. Giddings, “Grounding Systems and TheirImplementation,”
J. Audio Eng. Soc.
, June 1995.
A.H. Burdick,
A Clean Audio Installation Guide
, Benchmark MediaSystems, 1986.
C. Davis and D. Davis, “Grounding and Shielding Workshop,”
TechTopics
, Vol. 12 No. 10, Syn Aud Con, 1985.
P. Giddings, “An Introduction to Electromagnetic Compatibility (EMC)and Electromagnetic Interference (EMI) for Audio System Designers,”
J. Audio Eng. Soc.
Vol. 37 No. 7/8, 1989.
P. Giddings,
Audio Systems Design and Installation
, Howard W.Sams, 1990.
“IEEE Guide for the Installation of Electrical Equipment to MinimizeElectrical Noise Inputs to Controllers from External Sources,” IEEEStandard 518-1982, IEEE, 1982.
R.H. Kaufmann, “Some Fundamentals of Equipment Grounding CircuitDesign,”
AIEE Transactions
, November 1954, pp. 227-232.
S.R. Macatee, “Considerations in Grounding and Shielding Audi Devices,”
J. Audio Eng. Soc.
, June 1995.
Ralph Morrison,
Grounding and Shielding Techniques inInstrumentation
, 3rd ed., John Wiley and Sons, 1986.
R. Morrison,
Grounding and Shielding Techniques inInstrumentation
, 2nd ed., Wiley Interscience, 1977.
[Author’s note: Contains interesting information]
R. Morrison and W.H. Lewis,
Grounding and Shielding inFacilities
, Wiley Interscience, 1990.
N. A. Muncy, “Noise Susceptibility in Analog-Digital Signal ProcessingSystems,”
J. Audio Eng. Soc.
, June 1995.
Henry W. Ott,
Noise Reduction Techniques in Electronic Systems
,2nd ed., John Wiley and Sons, 1988.
C. Perkins, “Automated Test & Measurement of Common ImpedanceCoupling in Audio System Shield Terminations,”
J. Audio Eng.Soc.
, June 1995.
N. Violette and D. White,
Electromagnetic CompatibilityHandbook
, Van Nostrand Reinhold, 1987.
B. Whitlock, “Balanced Lines in Audio Systems—Fact, Fiction andTransformers,”
J. Audio Eng. Soc.
, June 1995.
J. Windt, “An Easily Implemented Procedure for Identifying PotentialElectromagnetic Compatibility Problems in New Equipment and ExistingSystems—The Hummer Test,”
J. Audio Eng. Soc.
, June1995.